In the manufacturing and maintenance of refrigerators, air conditioners, freezers, and other refrigeration equipment, copper tube brazing is one of the most critical processes. The sealing and pressure resistance of the system directly depend on weld quality—a tiny leak can lead to refrigerant loss, compressor damage, or even complete unit failure.
Traditional methods have long relied on oxy-acetylene cylinders as the heat source, but this approach has many inherent pain points:
• Significant safety hazards: High-pressure cylinder storage, transport, and use pose leak and explosion risks, flagged as major safety concerns by fire departments;
• Unstable weld quality: Acetylene flame temperature is divergent, creating a large heat-affected zone that can damage nearby components; carbon in the flame may produce soot at the weld point;
• Poor working environment: Combustion produces harmful gas, affecting workshop air quality;
• High operating costs: Cylinder rental, gas purchases, and transport management consume significant resources.
The oxyhydrogen flame copper tube welding machine from Hunan Okay Energy Technology Co., Ltd. offers a new process choice for the refrigeration industry. The equipment uses water and electricity to produce an oxyhydrogen gas mixture (HHO) via electrolysis, which when ignited creates a concentrated flame up to 3000°C specifically for brazing and welding copper and aluminum tubes.
Core Advantage Analysis
| Comparison Dimension | Traditional Oxy-Acetylene | Oxyhydrogen Generator |
| Raw Materials | Acetylene + Oxygen (cylinders) | Water + Electricity |
| Flame Temperature | ~3100°C (divergent) | 3000°C, concentrated & precise |
| Safety | High-pressure flammable gas | On-demand, no storage, multi-layer flashback protection |
| Weld Quality | Large HAZ, carbon black risk | Small HAZ, carbon-free, bright weld |
| Working Environment | Smoke & fume emissions | Combustion product only water vapor, zero pollution |
| Operating Cost | Ongoing gas purchases, high cost | Only water & electricity, ~60% savings |
When using an oxyhydrogen flame for copper tube brazing, the following process points should be noted:
• Surface Preparation: Remove oil, grease, and oxide layers from the joint area using sandpaper or a metal brush to ensure a clean surface. Note: Do not polish the surface, as this can reduce the capillary action essential for proper filler metal flow.
• Heating Method: Apply the flame evenly to the joint area, moving back and forth with the connection point as the center to ensure uniform heating of the entire region.
• Filler Rod Application: When the workpiece is heated to a dull red color, touch the filler rod to the joint. Allow the heat of the workpiece to melt the filler rod, which will then penetrate the joint by capillary action.
• Cooling & Cleaning: Allow the joint to cool naturally after welding. Residual flux is non-corrosive and requires no special post-weld cleaning treatment.
Technical Safety Guarantees
• On-Demand Gas Production, No Storage: Gas is produced only when the machine is running and stops immediately when turned off, completely eliminating the risks associated with high-pressure gas storage.
• Multi-Layer Flashback Protection: The system combines a wet flashback arrestor with an electronic flame arrestor, providing 100% effective flashback prevention.
• Multiple Electrical Protections: Built-in overpressure, overtemperature, water shortage, and overcurrent protection systems automatically trigger alarms and shut down the machine in case of any abnormality.
• Low-Pressure Gas Supply: Operating pressure is ≤0.1MPa, which does not fall under the category of pressure vessels, further enhancing safety.
The Okay Energy oxyhydrogen generator has been widely used in the production and maintenance of air conditioners, refrigerators, freezers, and other refrigeration equipment. With its safe, environmentally friendly, and efficient characteristics, it has gained recognition from numerous enterprises. The products have been exported to many countries and regions worldwide, serving welding needs in the motor, transformer, and refrigeration industries.