Product Introduction
With a concentrated 3000°C flame, the oxyhydrogen gas generator is purpose-built for transformer copper busbar, winding lead, and high/low voltage terminal welding. The minimal heat-affected zone prevents copper oxidation, deformation, and insulation damage, producing dense, flat joints with conductivity approaching the base material—fundamentally reducing contact resistance and ensuring long-term stability under high-current operation.
Only need water and electricity, produce gas on demand, with multiple anti-backfire devices, no need gas cylinder, it eliminates high-pressure storage and explosion risks; combustion yields only water vapor with zero emissions. One machine supports simultaneous multi-torch operation, delivering an efficient, safe, and clean welding solution for transformer manufacturing.
Product Features
Product Specifications
| Model Number | OH7500 |
| AC Voltage Requirement | 380V |
| Phase | three phase |
| Rated Power | 23 kw/h |
| Max. Gas Output | 7200L/h(adjustable) |
| Max. Working Pressure | 2 kg/cm2 |
| Max. Water Consumption | 4 L/h |
| Water Feed | auto |
| Dimensions - LWH | 1300*850*1910mm |
| Weight(kg) | 720 |
| Ventilation Space Requirement | 400mm in each direction |
Product Applications
Transformer Flat Copper Wire and Nut Welding
Transformer conductive connections often require welding flat copper wire ends to nuts, demanding high conductivity and tensile strength. The concentrated flame of the oxyhydrogen gas generator rapidly fuses the copper wire end to the nut, forming a dense metallurgical bond with low contact resistance that remains stable over long-term operation. The carbon-free, sulfur-free combustion prevents weld residue from contaminating transformer oil, safeguarding insulation performance.
Transformer Winding Magnet Wire Welding
After transformer winding is completed, magnet wire ends must be connected to leads or terminals. Traditional processes require pre-stripping the enamel insulation before welding—a cumbersome procedure. The concentrated high-temperature flame of the oxyhydrogen gas generator instantly vaporizes the enamel insulation while simultaneously completing fusion welding, eliminating pre-stripping and simplifying the process by over 50%. The precise flame produces minimal heat-affected zone, preserving insulation on adjacent coils, with full, dense, reliable weld points.
Flat Copper Wire and Flat Copper Wire Brazing
Transformer windings and conductive circuits often require butt or lap welding between flat copper wires. The micro-beam precision of the oxyhydrogen gas generator fuses two flat copper wires in a single operation, producing full welds without porosity or slag inclusion. Post-weld joint resistance is low, with conductivity approaching that of the base material. Multiple torches can operate simultaneously to meet high-efficiency mass production demands.
Flat Copper Wire and Flat Aluminum Wire Welding
Transformer lead-out connections often involve joining copper and aluminum, where oxide films and brittle intermetallic compounds can cause joint failure with conventional methods. The high-temperature reducing flame of the oxyhydrogen gas generator effectively strips the dense alumina layer from aluminum surfaces, enabling metallurgical bonding between fresh molten aluminum and copper under controlled thermal conditions. The weld features a uniform transition layer and stable contact resistance that resists galvanic corrosion and thermal cycling stress, with no corrosive flux required.
Flat Copper Wire and Flat Aluminum Wire Brazing
In transformer conductive circuits, flat copper wires must be reliably connected to copper busbars for high-current transmission. The concentrated, uniform heat input of the oxyhydrogen welder rapidly fuses the flat copper wire end to the busbar surface, producing smooth, dense welds with low contact resistance. The spatter-free, low-radiation process minimizes busbar thermal deformation, eliminating secondary straightening.